Many people feel overwhelmed by the installation of garage door sealers. In fact, there are 6 common types of garage doors, which are sectional, roll-up, side-sliding, side-hinged, and upward-sloping canopy. and retractable garage doors that tilt upward. We must understand these garage door workflows or how they work in order to have a good understanding of where the garage door seal brushes are installed.

The sectional garage door is the most popular type of sectional garage door in the United States, and it is made up of multi-fast panels. The panels are in close contact, so there will be no gaps between the panels. It is generally recommended to install a sectional top of the garage door, door side seals, and door bottom. Determine the length of the sealing brush according to the length and width of your own garage. Generally, you need 5 to 6 garage door sealing brush strips, which can not only ensure the beautiful appearance of the garage but also protect the car from being covered by ash.

Rolling shutter doors are mostly used in commercial garage doors and are generally seen in repair garages. This kind of door saves the position of the ceiling. Like its name, the working mode of the rolling shutter door is to roll up the iron sheet and hang it on the top of the door. Therefore, the rolling door is also installed with a sealing brush on the top, and on both sides and bottom of the door. The sealing brush not only plays the role of sealing and blocking dust but also can clean the dust.

Slide to the Side Garage Doors is a simple and flexible way to slide to the side of the garage and parallel to the wall. The bottom of the door is in close contact with the bottom surface, so it is recommended to install the garage door sealing brush strip on the top and both sides of the door.

Side-Hinged Garage Doors is an old-fashioned garage door, which is similar to the doors we usually have at home. There are two symmetrical wooden doors. The working mode is push-pull. Generally, the garage door sealing brush strip can be installed on the upper and lower parts of the door. Yes, two gaps closed in the middle of the door can be installed if necessary.

The working modes of Tilt-Up/Up and Over Canopy Garage Doors and Tilt-Up/Up and Over Retractable Garage Doors are not much different, but the installation positions are opposite. The former is installed facing outwards, while the latter is installed facing inwards. A garage door sealing brush strip is to be installed on the top, sides, and bottom of the door.